SKT-2-01
1
Safety regulations
•
Assembly, installation and service must be carried out by authorized and skilled electricians.
•
Switch off facility operating voltage or pull out mains plug before starting assembly or service
work.
•
Facility assembly:
In dust-free, dry environment, protected against humidity, vapors, splash water and moisture.
In a location protected against solar radiation. Not within close distance of heat sources. In
ambient temperature of <50°C.
•
Ensure sufficient ventilation of the device. Do not cover the ventilation slots! - Avoid short
circuits!
•
Damages arising from incorrect connection and/or improper operation are excluded from any
liability.
•
Please observe all relevant standards, regulations and guidelines regarding installation and
operation of antenna facilities.
•
Ground SAT earth stations using equipotential bonding rails according to EN 50083-1,
EN 60728-11:2010.
•
Do not carry out any installation and service work during thunderstorms.
1.1 Scope
This operating manual is valid for the SKT 2-01 with firmware version 3.60 and higher.
© AXING AG – state of the art: September 2012 – Reserving change in design and type
Safety regulations
SKT-2-01
Page 3