User Manual
3. Connect the battery to the receiver,
then stick the battery into the cabin,
making sure the battery is well secured.
Center Control Surfaces
With the transmitter turned on and the battery conected to the ESC(and installed in the
battery compartment), it is now possible to check the center of all control surfaces.
Observe the rudder to ensure it is properly centered as shown below.
Then observe the elevator to ensure it is properly centered as shown below.
www.modster.at
MODSTER Super Cub S2
4. Setup is done. Make sure you read
and follow all instructions in this manual
before start flying the airplane.
17