AEG IPE84571IB Benutzerinformation Seite 58

When you switch between the
modes the heat setting is set
back to 0.
Diameter and position of the cookware
Choose the mode applicable to the size and
the shape of the cookware. The cookware
should cover the selected area as much as
possible. Place the cookware centrally on the
selected area!
Place the cookware with the bottom diameter
smaller than 160 mm centrally on a single
section.
Place the cookware with the bottom diameter
larger then 160 mm centrally between two
sections.
6.2 FlexiBridge Standard mode
This mode is active when you activate the
hob. It connects the sections into two
separate cooking zones. The sides of the
58 ENGLISH
100-160mm
> 160 mm
zones which operate together in this mode
light up, and they are linked with shorter
illuminated lines. You can set the heat setting
for each zone separately. Use two left side
control bars.
Correct cookware position:
Incorrect cookware position:
6.3 FlexiBridge Big Bridge mode
To activate the mode touch
the correct mode indicator
connects three rear sections into one cooking
zone. The front section is not connected and
operates as a separate cooking zone. You
can set the heat setting for each zone
until you see
. This mode