Reset; Overview Of The 7-Segment Display; Error Codes - Resol VBus / EnOcean Montage, Anschluss, Installation

11

Reset

In order to reset the settings of the interface adapter to the factory settings, pro-
ceed as follows:
1. Briefly press the set button until -- is indicated.
2. Press the set button for approx. 10 s.
The display starts flashing.
3. Release the button.
The interface adapter is reset to factory settings.
12

Overview of the 7-segment display

Display Permanent
0 - 6 Channel display / chan-
nel selection
0. - 6. Display of channels
assigned
E0 - E9 Error code
[ ] Everything OK
o0 (not assigned)
Sd Access to MicroSD card MicroSD card
-- Reset is possible
A1 - A5 VBus ® sub-address of
the interface adapter
1.0. Version number
Off No supply voltage
available or device in
standby
Flashing Flashing Flashing once
quickly
EnOcean Teach-in Package
error process in received / data
progress traffic
MicroSD
error card update
enquiry
Reset in
progress
Setting the
address
13

Error codes

The following error codes can be indicated on the display:
Display Description
Error code
E0 No error
E1 Teach-in process unsuccessful, no EnOcean device recognised
during teach-in process or devices already taught-in
E2 MicroSD card: File error
E3 MicroSD card write-protected
E4 MicroSD card: File system error
E5 MicroSD card full
E6 EnOcean connection terminated, LED flashes red. Acknowledge the
error message by pressing the set button. [ ] appears.
E7 EnOcean device error (flashes alternately with the channel number)
Eo Error is reported via the feedback signal of the output
21