Troubleshooting - Sharp UA-PN1E Bedienungsanleitung

REPLACEMENT FILTER
MODEL
Consult your dealer when purchasing a
replacement filter.
Dust Collection and Deodorizing
Integrated Filter (1 unit)
UZ-PN1SF

TROUBLESHOOTING

Before calling for service, please review the Troubleshooting list below, since the
problem may not be the product malfunction.
It doesn't operate.
• Check if the AC adapter is correctly
connected to the product and the outlet.
(It may take some time until the
operation starts when after connecting
the AC adapter.)
Odour and smoke persists.
• Is the filter still in the plastic bag? Take
out the filter.
• Has the wind from the Air Outlet been
weakened?
In that case, clean the Bottom Cover,
the Pre-Filter and the Dust Collection
and Deodorizing Integrated Filter.
Air discharged from the
product has an odour.
• Check to see if the filters are extremely
dirty.
• Clean or replace the filters.
Dispose of used filters according to local
laws and regulations.
material:
• Polypropylene
• Polyethylene
• Activated carbon
Smell from a new product
and/or filter.
• Immediately after removing the
plastic bag, a slight odour may occur.
This odour is not harmful for filter
performance or human exposure.
The Plasmacluster Ion Lamp is
turned off.
• When the Plasmacluster Ion is set to
"OFF", the Lamp automatically turns off.
If you do not want the light to be off, set
the Plasmacluster Ion to "ON" setting.
(Page 5)
The LOW mode Lamp is
flashing.
• Unplug the product, wait one minute,
and then plug the product in again.
If the flashing repeats periodically,
please contact the customer service.
EN-9