SEVERIN UZ 3861 Gebrauchsanweisung Seite 11

∙ Children must not be
permitted to play with the
appliance.
∙ Caution: Keep any packaging materials
well away from children – these
materials are a potential source of
danger, e.g. of suffocation.
∙ Every time the appliance is used, the
main body including the power cord as
well as any attachment fitted should
be checked thoroughly for any defects.
Should the appliance, for instance, have
been dropped onto a hard surface, or if
excessive force has been used to pull
the power cord, it must no longer be
used: even invisible damage may have
adverse effects on the operational safety
of the appliance.
∙ Do not allow the appliance or its power
cord to touch hot surfaces or to come
into contact with any heat sources.
∙ After switching off, always wait until the
motor has come to a complete standstill
before removing the drive unit from
the processing bowl. Do not touch any
moving parts.
∙ Do not operate the appliance when the
bowl is empty.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
Before using for the first time
Before the appliance is used for the first
time, all parts must be thoroughly cleaned
as described in the section Cleaning and
care.
Short-time operation
The appliance is designed to be operated
without interruption for a maximum of 10
seconds, when it should be allowed to cool
down for approximately 1 minute.
Safety switch
This appliance is equipped with two safety
switches. The appliance can only be
switched on if the lid is correctly fitted and
the drive unit properly mounted on top of
the processing bowl.
Operation
∙ Fit the cutting blade unit into the bowl
before filling the bowl with the food
to be processed. Exercise extreme
caution: the blades are very sharp.
When handling the blades, always hold
them by their upper protective plastic
covering.
∙ Place the lid into the processing bowl,
ensuring that the blade unit shaft fits
through the opening in the lid.
∙ Fit the drive unit to the bowl.
∙ Insert the plug into the wall socket and
press the push switch in brief bursts until
the food being processed has reached
the required consistency.
∙ Avoid overfilling the bowl: the maximum
fill marks must not be exceeded.
Before the bowl is filled, the food to be
processed should be cut into pieces of
about 1 cm.
∙ After processing, always remove
the plug from the wall socket before
detaching the drive unit and removing
the lid. The blade unit must be removed
before the processed food can be taken
11