Safety Notes; Installation Instructions; Symbol Description - HANSGROHE Aquno Select M81 170 3jet sBox 73831 3 Serie Gebrauchsanleitung, Montageanleitung

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• If the SatinFlow starts to drip or run with it, the flow
rate of the angle valve on the hot water side must be
regulated downwards.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 12)
To adjust the hot water limiter. Using a hot water limiter
in combination with a continuous flow water heater is
not recommended.
Fault
SatinFlow too low / little water
Changeover to SatinFlow is stuck
Mixer dripping
To little water at the pull-out spout
Water escaping at the threaded
base
Pull-out length hose too short (less
than 500 mm)
2
max. 0,45 MPa
0,1 - 0,45 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
70°C / 4 min
Cause
- Nozzles and / or flow restrictor
fouled / calcified
- Changeover button fouled
- Cartridge defective
- Backflow preventer in the hose
connection and faucet aerator
calcified / fouled
- connection hoses not completely
screwed into basic body
- Hose weight assembled in wrong
position
Assembly (see page 4)
English
Maintenance (see page 20)
The check valves must be checked regularly according
to EN 806-5 in accordance with national or regional
regulations (at least once a year).
Dimensions (see page 14)
Flow diagram (see page 15)
Spare parts (see page 19)
XX = Colors
00 = Chrome Plated
67 = Matt Black
80 = Stainless Steel Optic
Special accessories (order as an extra)
extension #43333000 (see page 15)
Cleaning (see page 16)
Operation (see page 13)
Hansgrohe recommends not to use as drinking water
the first half liter of water drawn in the morning or after
a prolonged period of non-use.
Remedy
- Dismantle and clean nozzles and
flow restrictor.
- Detach and clean changeover
button
- Exchange cartridge
- Clean backflow preventer and
faucet aerator
- Tighten connection hoses by hand
- Assemble hose weight according
to the assembly instructions