Operation - GreenWorks G40T5 Bedienungsanleitung

ATTACHING THE EDGE GUIDE See Figure 2.
The edge guide can limit the cutting range of the cutting
■
line and reduce the risk of the rotating cutting line
causing damage.
T o u s e h t e e d g e g u d i
■
trimmer head.
ATTACHING GRASS DEFLECTOR See Figure 3.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
Remove the battery pack.
■
Invert the grass trimmer/edger to access the trimmer
■
head.
Slide the guard (1) into the slots on the trimmer head.
■
Align the screw holes on the guard (2) with the screw
■
holes on the trimmer head (3).
Insert the screw into the trimmer head, fastening the
■
guard in place.
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes resulting in
possible serious injury.
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
ATTACHING THE AUXILIARY HANDLE See Figure 4.
Ease the ends of the auxiliary handle slightly apart and
■
push it onto the shaft until it snaps into position.
Swing the auxiliary handle in the direction of the arrow
■
and engage it in the required position.
Insert the screw through the holes.
■
Screw the knob and tighten it firmly.
■
English (original instructions)
, e p e r s s h t e e d g e g u d i e
WARNING
WARNING
WARNING
WARNING
ADJUSTING LENGTH OF SHAFT (See Figure 5.)
The length of the shaft can be adjusted to suit the height
and reach of the user.
Remove the battery pack.
■
o n o t h t e
Hold the shaft firmly.
■
Depress lock button (1) and hold it in that position.
■
Pull or push the control handle (2) to the required
■
position.
Release the lock button (1).
■
Move the control handle (2) back and forth until it
■
engages.

OPERATION

Hold the power head with your right hand on the rear han-
with both hands while in operation. Power head should be
held at a comfortable position with the rear handle about
hip height. Always operate power head at full throttle. If de-
bris becomes wrapped around the attachment, RELEASE
THE SWITCH TRIGGER, and remove the debris.
TO INSTALL BATTERY PACK See Figure 6.
Place the battery pack in the trimmer. Align raised ribs
■
on battery pack with grooves in the trimmer's battery
port.
Make sure the latch on bottom of the battery pack
■
snaps in place and that battery pack is fully seated and
secure in the trimmer before beginning operation.
TO REMOVE BATTERY PACK See Figure 6.
Release the switch trigger and lock-out trigger to stop
■
the trimmer.
Press the power button to turn off the trimmer.
■
Press and hold the battery latch button at the bottom of
■
the battery pack.
Remove battery pack from the trimmer.
■
STARTING/STOPPING THE TRIMMER See Figure 6.
To start the string trimmer, press and hold the safety
■
lock button (1) and squeeze the trigger (2).
To stop the trimmer, release trigger to stop.
■
2
WARNING