Horizon Hobby Spektrum AR10360T Bedienungsanleitung Seite 14

EN
(AS3X) System Setup
Select Forward Programming -> Gyro Settings -> System Settings ->
• Relearn Servo Settings can be accessed if any changes are made to the
model configuration outside of Forward Programming. If any changes are
made to servo reversing, travel, sub-trim, wing type or tail type, you can
execute this function instead of restoring factory defaults and redoing the
entire setup.
• Orientation can be changed from this menu if the receiver mounting is
changed.
• Gain Channel enables you to change the channel you are using to
manage gain.
• SAFE/Panic Mode Setup
1. Panic
Select a channel to trigger Panic mode. Chose any channel that is
not used for a control surface, throttle, flight modes, or gain. We
recommend assigning the momentary I button for Panic.
Delay will cause a two second delay when exiting panic mode
Panic Flight Mode selects a Flight Mode to pull the gain values from
for Panic operation; select a Flight Mode that is setup with SAFE
Roll and Pitch values on this page represent angle limits while in
Panic mode.
2. Throttle To Pitch
Low Thr to Pitch Threshold determines the trigger point below which
the airplane will descend nose down at the chosen angle.
High Thr to Pitch Threshold determines the trigger point above
which the airplane climbs at the chosen angle.
3. Attitude Trim allows you to redo the Capture Level Flight Attitude, and/
or manually fine tune the values based on flight testing.
4. SAFE Failsafe Flight Mode allows you to select a flight mode (with
SAFE configured) to act as a failsafe mode. Making this selection
enables SAFE Failsafe.
5. Failsafe Angles determine the attitude the aircraft will maintain in the
event of a failsafe. Set pitch and bank angles to hold the aircraft in a
gentle gliding turn, preventing a flyaway.
• Utilities -> Copy Flight Mode Settings
Select a Source and Target Flight Mode to transfer all Flight Mode settings
from one Flight Mode to another. All settings in the Target Flight Mode will
be overwritten.
14