Configuration Menu; Configuration Mode - GYS GYSFLASH 30-12 HF Bedienungsanleitung

POWER SUPPLY MODE CONFIGURATION
POWER SUPPLY
U=13.5V
POWER SUPPLY
U=19.6V
POWER SUPPLY
U=19.6V
NOTE: Unlike other modes, Power Supply mode, the charger does not compensate voltage drop in the cables. In this case, the vol-
tage displayed on the screen corresponds to the output voltage of the charger (not the voltage on the clamps).

CONFIGURATION MENU

Access to configuration menu :
To browse in the sub menu press the
«Select» key :
Sub menu :
• Languages :
This menu enables to language selection (use the arrows to change the
language).
• Automatic restart :
Automatic restart only works with «Showroom» Mode and «Charge»
Mode. This feature enables charger to restart automatically and to restart
charging after a cut in power. This feature is set as default => Display
«Configuration | Restart : ON».
• Lock Showroom :
To lock the device in Showroom Mode (to avoid misuse)
GYSFLASH 30-12 HF
I<30A
2.0V 16.0V
2.1V 16.1V
... ...
I<30A
16.0V 30.0V
2A 2A
3A 3A
... ...
I<10A
30A 15A
3 sec - Mode
MODE
languages > restart > lock showroom > cable calibration > ADVANCED
SELECT
MENU > Reset Memory
With battery connected :
• Push the START/STOP key to start the mode.
• During use, the current consumed and the instan-
taneous voltage are displayed.
POWER SUPPLY START UP
POWER SUPPLY
U=19.6V I<15A

CONFIGURATION MODE

SETTINGS
English
SETTINGS
restart:
SETTINGS
lock showroom:
SETTINGS
Cables Testing:
Press START
SETTINGS
Advanced Menu:
Press START
SETTINGS
Reset Memory:
Press START
EN
POWER SUPPLY
U=19.6V I=10A
English
Francais
Deutsch
Nederlands
Espanol
Portugues
Italiano
Russian
ON
ON
OFF
Y (yes)
N
N (no)
Test Cables
Advanced menu
Reset Memory
13