GYS GYSFLASH 30-12 HF Bedienungsanleitung Seite 11

CHARGE MODE CONFIGURATION DEPENDING
ON THE BATTERY TYPE
CHARGE
gel/AGM
CHARGE
gel/AGM
CHARGE
gel/AGM
Start up :
• Connect the clamps : red to the (+) and
black to the (-) of the battery.
• Push the START/STOP key to start
charging, a loading bar displays.
• Push the START/STOP key again to stop
the charge.
NB: When the charge ends (100%), if the battery remains connected the charger maintains the charge level of the battery by
applying a floating voltage.
Precaution: Check the electrolyte level and fill if necessary before charging.
DIAG MODE AND DIAG+ MODE
On a stationary vehicle the GYSFLASH supplies up to 30A to test high-energy consumers: engine fan, window regulator, electronic
suspension, etc... By supplying a steady voltage:
DIAG FUNCTION
- 13.5V
DIAG+ FUNCTION
- 12V to 14.8V
Voltage adjustment (only in Diag+ mode)
It is possible to adjust the voltage in steps of 0.1V according to manufacturer's specifications.
DIAG + MODE CONFIGURATION
DIAG+
U=13.5V
DIAG+
U=13.2V
Precaution : Before using the Diag Mode. If the screen displays a current greater than 10A, it indicates the battery is discharged.
The device will start charging automatically. Check all electrical consumers are switched off on the vehicle. Wait until the current falls
below 10A and then re-launch the diagnostic.
GYSFLASH 30-12 HF
12V
80Ah
12V
80Ah
12V
80Ah
CHARGE MODE START UP
12V
12.0V
12V
12.1V
...
14.8V
easy
gel/AGM
liquid
Charging curves available if activated in
expert
«Advanced Menu».
10Ah
20Ah
Only for liquid, gel/AGM and expert
...
charging curves.
400Ah
CHARGE 10%
80Ah
gel/AGM
Start up :
• Connect the clamps : red to the (+) and
black to the (-) of the battery.
• Push the START/STOP key to start the
mode.
• During use the current consumed and the
instantaneous voltage are displayed.
DIAG MODE START UP
CHARGE
gel/AGM
CHARGE 100%
80Ah
gel/AGM
CHARGE
10%
80Ah
gel/AGM
EN
100%
80Ah
11