Axis Communications Q60 Serie Installationsanleitung Seite 23

8. Slide the unit holders on the network camera into the slots in the mounting plate and
rotate the camera unit.
9. Install the supplied midspan, see the Installation Guide delivered with the midspan or
find it on www.axis.com
Install the camera with a drop ceiling mount
WARNING
The combined weight of the camera and ceiling mount is approximately 3200 g (7.1 lb).
Make sure that the ceiling material is strong enough to support this weight.
NO TICE TICE
NO NO TICE
The ceiling tile should be 5–60 mm (3/16–2 3/8 in) thick.
1. Remove the ceiling tile in which the drop ceiling mount is to be fitted.
2. Cut a hole in the ceiling tile for the drop ceiling mount. Use the supplied template to
mark the position and cut around the template.
1
Ceiling tile
2
Hole diameter 225 mm (8 7/8 in)
3. Assemble the ceiling bracket and attach it to the ceiling tile. Make sure the arrows on
the mounting plate and the ceiling bracket are pointing in the same direction for the
logotypes on the camera and the trim ring to align.
4. Tighten the bracket arm screws.
5. Loosen the camera base lid screws and remove the camera base lid.
6. Route and connect the network cable and, if used, the multi-connector cable to the
camera.
NO TICE TICE
NO NO TICE
• Be careful not to damage the cables when connecting them.
• Make sure that the foam gasket holes are aligned with the cable tracks. If using a
multi-connector cable, remove the cut-out piece for the multi-connector cable from
the foam gasket.
AXIS Q60 Series
23
EN