Axis Communications Q60 Serie Installationsanleitung Seite 16

AXIS Q60 Series
SD card slot
NO TICE TICE
NO NO TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects, or excessive force when
inserting or removing the SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product
is running. Unmount the SD card from the product's webpage before removal.
This product supports SD/SDHC/SDXC cards.
For SD card recommendations, see axis.com.
Control button
For location of the control button, see .
The control button is used for:
• Resetting the product to factory default settings. See page 27.
• Connecting to an AXIS Video Hosting System service. To find out more about this
service, see axis.com
Power button
Press and hold the power button to temporarily power the product when the dome cover is
removed. The power button is also used with the control button to reset the camera to factory
default settings. See page 27.
Multicable connectors
When connecting external equipment to the Axis product, an Axis multicable is required in order
to maintain the product's IP rating. The Axis multicable can be purchased from your Axis reseller.
To locate the multi-connector, see .
The multicable provides the following connectors:
Power connector - 3-pin terminal block used for power input. Use a Safety Extra Low Voltage
(SELV) compliant limited power source (LPS) with either a rated output power limited to ≤100 W or
a rated output current limited to ≤5 A.
Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is
used from a stereo signal).
Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address
(PA) system or an active speaker with a built-in amplifier. A stereo connector must be used for the
audio out.
16