Axis Communications Q60 Serie Installationsanleitung Seite 21

• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
Change the dome cover (optional)
The premounted clear dome cover can be replaced if you want to use the smoked dome cover or
if the dome cover is scratched or damaged. Spare dome covers can be purchased from your Axis
reseller
For location of the components, see Hardware overview on page 12.
1. Loosen the dome ring screws and remove the dome cover.
2. Remove the dome bracket screws, the dome bracket, and the dome cover from the dome
ring.
3. Attach the dome bracket and the dome cover to the dome ring and tighten the screws
(torque 1.2 Nm).
4. To install an SD card, see How to install an SD card (optional) on page 21.
5. Attach the dome cover to the top cover and tighten the screws (torque 1.5 Nm).
How to install an SD card (optional)
Installing an SD card is optional. A standard or high capacity SD card (not included) can be used to
store recordings locally in the product.
1. Loosen the dome ring screws and remove the dome cover.
2. Insert an SD card into the SD card slot.
3. Attach the dome cover to the top cover and tighten the screws (torque 1.5 Nm).
How to install the camera
The Axis product can be mounted with the cables routed through or along the wall or ceiling.
Choose one of the following ways to install your camera:
• Install the camera with a hard ceiling mount on page 21.
• Install the camera with a drop ceiling mount on page 23.
• Install the camera with a bracket mount on page 25.
Install the camera with a hard ceiling mount
1. Prepare the ceiling for installation of the mounting plate. Use the mounting plate as
a template to position the holes. Make sure to use drill bits, screws and plugs that
are appropriate for the material.
AXIS Q60 Series
21
EN