Ice Maker - Siemens GS D Serie Gebrauchsanleitung

Ice maker

Fault
The ice maker doesn't
work.
The ice maker does
not make enough ice
or the ice is deformed.
Ice dispenser does not
function.
The "lock" and "on/
off" buttons flash.
Possible cause
Ice maker is not
connected
to the mains supply.
The ice maker is
switched off.
Ice maker does not
receive any fresh
water.
The freezer
compartment
temperature is too
warm.
The appliance or ice
maker has only just
been switched on.
A lot of ice has been
taken.
Low water pressure.
The freezer
compartment
temperature is too
warm.
Screen on the water
supply is dirty.
Water has escaped
from the pipe system.
The integrated
AquaStop system has
interrupted the water
supply.
Remedial action
Call customer service.
Switch on the ice maker (see "Ice
maker").
Ensure that the water is properly
connected.
Check freezer compartment
temperature and, if required, set
slightly colder.
Approx. 24 hours is needed until ice
production starts.
Approx. 24 hours is needed until
the ice cube container is filled again.
Connect the appliance
to the stipulated water pressure only
(see chapter "Connecting
the appliance", section "Water
connection").
Set temperature colder.
Clean the screen.
Switch off the water supply
and inform customer service (see
chapter entitled Alarm function).
en
43