Light (Led); Tips For Saving Energy - Siemens GS D Serie Gebrauchsanleitung

en
Interior fittings
All variable parts of the appliance can be
taken out for cleaning (see chapter
Interior fittings).
Cleaning the ice cube container
If ice cubes have not been dispensed for
a prolonged period, they will shrink, have
a stale taste and stick together.
Therefore, the ice cube container should
be cleaned regularly.
ã=
Caution
A full ice cube container is heavy.
1. Remove the ice cube container.
2. Pull out the container, empty
and clean with lukewarm water.
Note
Do not clean the container by
immersing it in water. Water must not
get inside the container!
3. Thoroughly dry the container
to prevent new ice cubes from
sticking.
4. Insert the ice cube container.
Ice cube production continues.

Light (LED)

Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.
40

Tips for saving energy

Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Do not block the ventilation openings
■
in the appliance.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
■
possible.
Ensure that the freezer compartment
■
door is always closed properly.
Occasionally clean the rear
■
of the appliance to prevent an
increased power consumption.
If available:
■
Fit wall spacers to obtain the indicated
energy rating of the appliance (see
Installation instructions). A reduced
wall gap will not restrict the function
of the appliance. The energy rating
may then increase slightly. The gap
of 75 mm must not be exceeded.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.