Using The Laser - DeWalt DCE089G18 Bedienungsanleitung

Measure the distance between
11.
measurement is greater than the values shown
below, the laser must be serviced at an authorized
service center.
Distance from
to
a b
4.0 m
5.0 m
6.0 m
7.0 m

Using the Laser

Leveling the Laser
As long as the laser is properly calibrated, the laser is
self-leveling. Each laser is calibrated at the factory to
find level as long as it is positioned on a flat surface
within average ± 4° of level. No manual adjustments
are required.
If the laser has been tilted so much that it cannot
self-level (> 4°), the laser beam will flash. There are
two flashing sequences associated with the out of level
condition.
• Between 4° and 10° the beams flash with a constant
blink cycle
• At angles greater than 10° the beams flash with a
three blink cycle.
When the beams flash THE LASER IS NOT LEVEL
(OR PLUMB) AND SHOULD NOT BE USED FOR
DETERMINING OR MARKING LEVEL OR PLUMB.
Try repositioning the laser on a more level surface.
Using the Pivot Bracket
The laser has a magnetic pivot bracket (Figure
permanently attached to the unit.
and . If the
a f
Allowable Distance
Between and
a f
3.5 mm
4.4 mm
5.3 mm
6.2 mm
H 1
WARNING:
Position the laser and/or wall mount
on a stable surface. Serious personal injury
or damage to the laser may result if the laser
falls.
• The bracket has a fine adjustment knob (Figure
) to help you line up the laser beams. Place the
H 2
unit on a flat level surface and turn the knob to the
right to move the beams to the right, or turn the knob
to the left to move the beams to the left.
• The bracket has a keyhole slot (Figure
be hung from a nail or screw on any kind of surface.
• The bracket has magnets (Figure
the unit to be mounted to most upright surfaces
made of steel or iron. Common examples of suitable
surfaces include steel framing studs, steel door
frames, and structural steel beams. Before attaching
the pivot bracket against a stud (Figure
the Metal Enhancement Plate (Figure
opposite side of the stud.
Maintenance
• To maintain the accuracy of your work, check the
laser often to make sure it is properly calibrated.
See Field Calibration Check.
• Calibration checks and other maintenance repairs
may be performed by D
• When not in use, store the laser in the kit box
provided. Do not store your laser at temperatures
below -5˚F (-20˚C ) or above 140˚F (60˚C).
• Do not store your laser in the kit box if the laser is
wet. The laser should be dried first with a soft dry
cloth prior to storage.
Cleaning
)
Exterior plastic parts may be cleaned with a damp
cloth. Although these parts are solvent resistant,
NEVER use solvents. Use a soft, dry cloth to remove
moisture from the tool before storage.
) so it can
I
) which allow
J 1
), place
J 2
) on the
J 3
WALT service centers.
E
GB
17