Navigation - Endress+Hauser Promag 800 Installationsanleitung

Activate SW option

Navigation

Description
User entry
Software option overview
Navigation
Description
Endress+Hauser
 System → Software configuration → Activate SW option
Enter the application package code or code of another re-ordered
functionality to enable it.
Enter application package code or code of the functionality ordered
separately to activate it.
Additional information:
- If a measuring device was ordered with an add-on software option,
the activation code is programmed into the measuring device ex
factory.
- After entering the activation code: Check whether the new
software option is displayed in the "Software option overview"
parameter and therefore active.
NOTE
If an an invalid code is entered the software options that have
already been activated are invalidated!
Before entering a new activation code: Create a record of the
existing activation code.
Positive integer
 System → Software configuration → Software option
overview
Shows all enabled software options.
Displays all software options included in the order ex factory or
ordered at a later date that have been enabled via the operating
interface.
Additional information:
If a new software option is not displayed after entering the
activation code, the code entered was inaccurate or invalid. In this
case, contact the appropriate Endress+Hauser sales organization to
activate the software option.
EA01366D

9