Safety Instructions - Endress+Hauser Promag 800 Installationsanleitung

EA01366D
1. www.endress.com/deviceviewer
2.
Ser. No.: 12345
5

Safety instructions

• Only use original parts from Endress+Hauser.
• Comply with national regulations governing mounting, electrical installation,
commissioning, maintenance and device alteration procedures.
• The specialized technical staff involved in the mounting, electrical installation,
commissioning, maintenance and alteration of the measuring devices must meet the
following requirements:
• Specialized technical staff must be trained in instrument safety.
• They must be familiar with the individual operating conditions of the devices.
• In the case of Ex-certified measuring devices, they must also be trained in explosion
protection.
• The measuring device is energized! Risk of fatal injury from electric shock. Open the
measuring device only when the device is de-energized.
• For measuring devices intended for use in hazardous locations, please observe the
guidelines in the Ex documentation (XA).
• For measuring devices in safety-related applications in accordance with IEC 61508 or
IEC 61511: following alteration, re-commission the device in accordance with the Operating
Instructions. Document the alteration.
• Before removing the device: set the process to a safe state and purge the pipe of dangerous
process substances.
• Danger of burns due to heated surfaces! Before commencing work: allow the system and
measuring device to cool down to a touchable temperature.
• In the case of devices in custody transfer, the custody transfer status no longer applies once
the seal has been removed.
• The Operating Instructions for the device must be followed.
• Risk of damaging the electronic components! Ensure you have a working environment
protected from electrostatic discharge.
• After removing the electronics compartment cover: risk of electrical shock due to missing
touch protection!
Turn the measuring device off before removing internal covers.
6
Order code Description
3.
=
?
4.
1. www.endress.com/deviceviewer
2. Enter the serial number of the modification kit,
search for the product data and click "Order code".
3. The order structure of the modification kit is
displayed.
4. Check the order number of the modification kit.
• Check the serial number against the serial number of
the original device.
• Does the configuration of the modification kit match
the ordered configuration?
= YES, the modification kit may be used for the
measuring device.
= NO, the modification kit may not be used for the
measuring device.
Endress+Hauser