Herunterladen Inhalt Inhalt Diese Seite drucken

Thermostat Einstellen/Warten; Thermostat Adjusting/Servicing; Regolazione/Manutenzione Del Termostato - HANSGROHE PHARO Aquafun 120 Steam L Montageanleitung

Inhaltsverzeichnis

Werbung

Thermostat einstellen/warten

Thermostat Adjusting/Servicing

Regolazione/manutenzione del termostato

Deutsch
Thermostat einstellen:
• Umstellgriff (1) aufstecken, Schraube fest-
drehen (Inbus SW 4).
• Umstellgriff in Stellung "Handbrause" (2)
stellen und öffnen.
• Thermostat auf 38 °C (3) justieren.
• Befestigungsschraube (5) Thermostatgriff
lösen.
• Thermostatgriff abnehmen.
• Thermostatgriff senkrecht ausrichten und
aufstecken (roter Knopf (4) zeigt nach oben).
• Thermostatgriff festschrauben (5).
Hinweis:
Bei
Frostgefahr
und
Entleerung
Rohrleitung:
Regeleinheit
Umstellgriff öffnen und die Installations-
einheit durch Ausblasen mit Pressluft trocknen
(wasserfrei).
48
All manuals and user guides at all-guides.com
Adjusting the thermostat:
• Push on the selection knob (1) and tighten
the screw (SW 4 socket wrench).
• Set the selection knob to the "Handbrause"
(hand shower) position (2) and open it.
• Adjust the thermostat to 38 °C (3).
• Loosen the fixation screw (5) at the thermo-
stat's knob.
• Remove the thermostat knob.
• Vertically position the thermostat knob and
plug it on (red button (4) points upwards).
• Tighten the thermostat knob (5).
Note:
der
In cases of frost danger and for pipeline
ausbauen,
drain: Uninstall the regulation unit, open the
selection knob and dry the installation unit
by blowing compressed air through it (water-
less).
English
Italiano
Regolazione del termostato:
• Applicare l'impugnatura (1) e serrare a
fondo la vite (brugola da 4).
• Posizionare l'impugnatura su "Doccia
manuale" (2) ed aprirla.
• Regolare il termostato su 38 °C (3).
• Allentare la vite di fissaggio (5)
dell'impugnatura del termostato.
• Togliere l'impugnatura del termostato.
• Posizionare verticalmente l'impugnatura
del termostato ed applicarla (pulsante rosso
(4) verso l'alto).
• Avvitare l'impugnatura del termostato (5).
Avvertenza:
In caso di pericolo di congelamento ed
evacuazione della tubazione: smontare il
regolatore, aprire l'impugnatura ed asciugare
il gruppo di installazione con aria compressa
(priva di acqua).

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis