Klarstein BARISTOMAT 10033138 Bedienungsanleitung Seite 27

Inserting the milk tank
1 Make sure that the milk pipe is in the top of the milk tank.
2 Place the upper part (9) on the lower part of the milk tank (7).
3 Insert the milk tank on the side of the device. Make sure that you insert the
tank in such a way that the milk pipe sits in the pipe guide on the device.
Note: The device continuously generates a simple error tone if the milk tank or
the filter insert has not been inserted or has not been inserted correctly.
4 Attach the frother to the appliance. As a precaution, direct the outlet of the
frother towards the centre of the drip grid or into the inside of a suitable
container that you place on the drip grid to avoid accidental burns.
Filling the milk tank
Fill the milk tank with milk. Make sure to fill it at a level between the MIN and MAX
marks on the milk tank.
TIP: Always use fresh milk to fill the milk tank in order to achieve the best results
and to prevent possible food poisoning.
Note: If you are using milk for a preparation, clean the milk system of the device
after completing the preparation as described in CLEANING AND CARE in order
to keep the device functional.
Filling the water tank
Note: Always use cold water to fill the water tank. Never use warm or hot water.
1 Fill the water tank with water. Make sure that the amount filled is within the
MIN and MAX marks in the water tank.
2 Close the lid of the water tank until it clicks into place.
EN
27