Unpacking - Klarstein BARISTOMAT 10033138 Bedienungsanleitung

INSTALLATION

Unpacking

Unpack your device and remove all packaging materials from the inside and
outside of the device and its components.
Cleaning
• Clean the outside of the device with a soft and damp cloth.
• Wash the removable parts with warm water, a food-safe, neutral detergent,
and a non-abrasive sponge.
• Rinse and dry the parts thoroughly. Reattach the components to the device.
Placement
• Place the device on a flat, clean, food-safe, and heat-resistant worktop near an
electrical outlet.
• The device has an emergency cooling function if the device becomes too hot
during operation. Make sure to keep the steam outlet (18) on the front of the
device free of obstacles.
• Place the device far away from heat sources such as stovetops, open flames
and direct sunlight in order to ensure that the device functions properly and
to prevent the housing from being deformed by heat.
Power supply
• This device uses a grounded power supply with 220-240 V ~ 50/60 Hz.
• Make sure the outlet meets the specifications for the device and has been
installed by a certified electrician.
• Make sure that the power cord does not come into contact with hot surfaces
or
• any other sources of heat.
• Run the power cable behind the device to the socket. To prevent the device
from being accidentally torn down, the power cord must not hang over the
edge of the work surface.
• If you disconnect the device from the power supply, switch the device off and
pull the plug out of the socket to prevent damage to the device.
• Disconnect the device from the power supply before cleaning the device and
when it is not in use.
EN
23