Pairing Function - Reely Black Rocket X V2 Bedienungsanleitung

12. Pairing function

To ensure that the 2.4 GHz remote control can transmit a signal without interference, the remote control and receiver
must have the same digital code. The digital encoding (connection between the remote control and receiver) can be
configured using the pairing function.
The remote control and receiver are usually already paired when they leave the factory and can be used straight away.
The devices only need to be paired again if the remote control or receiver has been replaced or to correct a malfunc-
tion.
If the model boat does not respond to the control signals from the transmitter, proceed as follows:
• Switch on the transmitter, the transmitter power LED must glow steadily.
• Remove the canopy and place the model boat on the boat stand so that the propeller can turn freely.
Warning!
Never reach into the propeller. The drive could start up unintentionally. The running propeller can cause
severe injury!
• Connect the drive battery to the speed controller.
• Press and hold down the pairing button (1) on the receiver for about
a second.
• The receiver LED should now flash red and then light up green. The
receiver is now paired with the transmitter.
• Check whether the model boat responds correctly to the control
commands from the transmitter.
Figure 14
53