Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
5. Fitting castors
Before using the appliance, the castors must be
fitted!
Carefully place the appliance on the floor with the
underside facing upwards. The surface must not
be too hard – paint or appliance damage!
Installing the castors between the outer-most rib
on each end of the radiator and its adjacent rib
using the wing bolts provided.
Tighten the wing bolts and carefully turn the radi-
ator back on the castors.
6. Operation
To use, insert the plug in to the socket.
Indicator lamp
The indicator lamp lights up when the heating device
is ready for use.
Selecting the output
The output switch (A) enables you to select three dif-
ferent heat outputs. When set to 0, the device is
switched off.
Output
Type
Level I
RD 1007 TS
500 W
RD 1009 TS
600 W
RD 1011 TS
800 W
EN-5
Output
Output
Level II
Level III
1000 W
1500 W
1400 W
2000 W
1700 W
2500 W
RD 1007 TS, RD 1009 TS, RD 1011 TS
Thermostat
To achieve a specific room temperature, set the con-
troller knob (B) to the highest value. Operate the appli-
ance at full power until the required room tempera-
ture is reached. Set back the thermostatic controller
until the appliance switches off with an audible "click".
This temperature will be kept almost constant by the
thermostatic control switching on and off automati-
cally.Please note that the appliance can only be
switched on when the thermostat setting is higher
than the room temperature.
7. Winding the cable
When unplugged, the power cable can be wound
around the cable holder (C).
2101/A
www.dimplex.eu
Werbung
