AEG RV 4.3 Bedienungsanleitung Seite 28

All manuals and user guides at all-guides.com
28 www.aeg-automotive.com
Image 8
Place the red transmitter cable sideways into the
clamp connector (7) (see image 9).
Image 9
using a pair of pliers (not included) push the
protruding metal contact into the cable clamp (7).
This will connect the two cables.
Image 10
Close the cable clamp (7) fuse cover.
Image 11
using the second cable clamp (7) connect the vehi-
cle's 12 V - (negative) reversing light cable with the
black transmitter cable as shown in images 8 - 11.
Then reconnect the negative cable to the vehicle's
battery.
Caution!
If you are unfamiliar with the I installation and the
connections or are unsure with one of these steps,
please consult a specialist regarding the installation!
There is a risk of property damage or personal
injuries!
Step 8: Installing the transmitter
Secure the transmitter with a suitable fastener, e.g.
two cable ties. Be sure there are no electrical loads
in the direct vicinity of the transmitter to avoid
impairing the transmission. Now secure the cables
for the camera and transmitter run in the void of
the trunk with cable ties (4). The cables run may not
interfere with the vehicle's functionality!
Step 9:Check the transmitter power supply cable
First engage the hand brake and be sure the vehicle
is not shifted into gear. Vehicles with automatic
transmission must be in "P" for parking lock. Turn
the ignition to II but do not start the engine! Push
the button (12) to power on the monitor. If the
transmitter is correctly connected, a signal will now
be transmitted to the monitor when putting the
car into reverse and the monitor will display the
camera's viewing range.
If no image is displayed on the monitor, you can
further check the camera power supply with the
hand brake engaged, ignition turned (II) and the
vehicle in reverse with a simple test. Do not start
the engine! Completely cover the camera with
both palms cupped to darken the camera surround-
ings and activate the night vision sensor. Leave a
slight opening between your thumbs and look into
your palms. If the camera is active, all 7 LEDs around
the camera will light up red. If the LEDs do not light
up, check the camera's cable and terminal connec-
tions. Also see "Troubleshooting".