Operating Conditions - Sauter OFL-Serie Betriebsanleitung

4. Operating conditions for OFL1.0, OFL2.0, OFL2.0-MINI, and OFL2.0-AD43
and CRT and FT router tables
Work with components listed herein must be carried out exclusively in dry environ-
ments to exclude putting users at risk.
Parts have also not been designed for outdoor use. For this reason, work in an adequa-
tely protected workshop.
Make sure not to work in a corrosive environment to guarantee a long service life and
associated functionality as well as safety.
Compliance with additional requirements may be necessary for use in tropical climates.
For this purpose, observe the operating manual of the router or router motor or contact
us for advice.
Always work on an even, clean surface to guarantee maximum stability when routing.
Consequently, the insert plate of the router lift must always be horizontal.
Additionally make sure all conditions for the used router tables, routers, and router
motors made by third-party suppliers have been complied with. For this purpose, read
the corresponding manufacturer's user manual.
Using accessory ADAP43-OFL (part of OFL2.0-AD43) without sauter OFL1.0 or OFL2.0
is not permitted at any time. Commissioning is only permitted using a corresponding
CE-compliant router table.
Accessory ADAP43-OFL (part of OFL2.0-AD43) must be permanently and positively
installed using a screw connection including self-locking washers (included in the scope
of delivery) and the attachment screws must be tightened on the installation plate to
the recommended torque of 13 Nm. Recheck this prior to each use. This is the only
way to guarantee that the unit does not come loose.
41