Kessel SonicControl Einbau- Und Betriebsanleitung Seite 27

SonicControl menu texts
0. System info
0.1 Data exchange
1. Information
1.1 Hours of operation
1.2 Log book
1.3 Control type
1.4 Maintenance date
1.5 Current measured values
1.6. Parameters
1.7 Measuring data
1.8 Disposal
2 Maintenance
2.1 Manual operation
2.3 Maintenance date
2.4 Maintenance done
2.5 Calibration of SonicControl
2.6 Sensor diagnosis
3 Settings
016-283
0.1.1 Software update
0.1.2 Read data
0.1.3 Read in parameter
0.1.4 Load language package
0.1.6 Save language package
1.1.1 Total running time
1.1.2 Power outage
1.1.3 Operation, layer thickness pre-
alarm
1.1.4 Operation, layer thickness alarm
1.1.5 Temperature alarm
1.1.7 Overvoltage
1.1.8 Undervoltage
1.1.9 Lowest temperature of the day
1.1.10 Highest temperature of the day
1.5.1 Layer thickness
1.5.2 Separator system temperature
1.5.3 Temperature
1.5.5 Battery voltage
1.5.6 Mains voltage
1.6.1 Alarm layer thickness
1.6.2 Pre-alarm layer thickness
1.6.3 Temperature alarm
1.6.4 Start of measuring range
1.6.5 End of measuring range
1.6.6 Measuring interval
1.6.7 Level comparison
1.8.1 Last disposal
2.1.1 Layer thickness
2.1.4 Potential-free contact
2.1.5 Ext. audible alarm
2.1.6 Communication
2.3.1 Last maintenance
2.3.2 Next maintenance
Installation and operating instructions
0.1.1.1 Software update (CU)
0.1.1.2 Module update (EXB)
0.1.1.3 Printed board update (EXB)
dd.mm.yy
hh:mm:ss
dd.mm.yy
hh:mm:ss
27 / 96