Getting Started - Modster VECTOR SR48 BRUSHLESS Betriebsanleitung

Boat Batteries Installation Boat Batteries Installation Boat Batteries Installation
1 1 1
Unlock Unlock Unlock
Lock Lock Lock
1. Rotate the hatch of the hull cover by clockwise to unlock the hatch. 1. Rotate the hatch of the hull cover by clockwise to unlock the hatch. 1. Rotate the hatch of the hull cover by clockwise to unlock the hatch.
2. Open the hull cover. 2. Open the hull cover. 2. Open the hull cover.
3. Adhere included loop tape or velcro tape to the battery. 3. Adhere included loop tape or velcro tape to the battery. 3. Adhere included loop tape or velcro tape to the battery.
4. Secure the boat battery on the hook strip in the boat. 4. Secure the boat battery on the hook strip in the boat. 4. Secure the boat battery on the hook strip in the boat.
5. Secure the battery in the hull with the hook and loop strap as shown. 5. Secure the battery in the hull with the hook and loop strap as shown. 5. Secure the battery in the hull with the hook and loop strap as shown.
Check Radio System Check Radio System Check Radio System
CAUTION: Always keep all body parts, hair and dangling or loose items away from a spinning propeller, CAUTION: Always keep all body parts, hair and dangling or loose items away from a spinning propeller, CAUTION: Always keep all body parts, hair and dangling or loose items away from a spinning propeller,
as these can be entangled. as these can be entangled. as these can be entangled.
NOTICE: Always power on the transmitter before powering on the ESC. Always power off the ESC before NOTICE: Always power on the transmitter before powering on the ESC. Always power off the ESC before NOTICE: Always power on the transmitter before powering on the ESC. Always power off the ESC before
powering off the transmitter. Never transport the boat with the battery connected to the ESC. powering off the transmitter. Never transport the boat with the battery connected to the ESC. powering off the transmitter. Never transport the boat with the battery connected to the ESC.
1. Turn the transmitter throttle and rudder trim to the middle position.
2. Power on the transmitter.
3. Connect a fully charged battery to the ESC.
4. Ensure the rudder moves in the proper direction when the controller is moved left or right.
5. Pull the throttle to max power postion, then return the throttle to min power position, ensuring the
propeller turns counterclockwise. The ESC auto-sensing voltage cutoff function will engage when the ESC
detects a low battery charge. Release the throttle and recharge the battery when necessary.
NOTICE: Read completely the radio appendix for more detailed instruction of using the radio. Make sure NOTICE: Read completely the radio appendix for more detailed instruction of using the radio. Make sure
NOTICE: Read completely the radio appendix for more detailed instruction of using the radio. Make sure
you have totally studied the radio manual appendix before you really start operating the boat with the you have totally studied the radio manual appendix before you really start operating the boat with the
you have totally studied the radio manual appendix before you really start operating the boat with the
radio. radio.
radio.

Getting Started

Getting Started Getting Started
1. Power on the transmitter.
2. Connect a fully charged battery.
3. Test the transmitter's control of the boat with the boat on the display stand.
4. After launching the boat in the water, start driving slowly. If the boat does not go straight, adjust the
trimmer on the transmitter to run it straight.
5. Power off the ESC and disconnect the battery packs.
6. Always turn off transmitter at last.
7. Allow the motor, ESC and battery packs to cool before charging the battery or operating the boat again.
2 2 2
open open open
4 / 12 4 / 12 4 / 12
5 5 5
3 3 3
4 4 4