Herunterladen Inhalt Inhalt Diese Seite drucken

Modster VECTOR SR48 BRUSHLESS Betriebsanleitung Seite 10

Quelle: modster.at
Vorschau ausblenden Andere Handbücher für VECTOR SR48 BRUSHLESS:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Boat tends to turn one
direction
Rudder does not move
Controls reversed
Motor or ESC overheats Blocked water cooler tubes
Motor power pulses
then motor loses power
Boat does not link (after
binding) to transmitter
Rudder or rudder trim is not centered
Vertical fins of trim tabs are angled
incorrectly
Rudder, linkage or servo damage
Wire is damaged or connections are
loose
Transmitter is not bound correctly or
the incorrect boat was selected
BEC (Battery Elimination Circuit) of
the ESC is damaged
ESC switch is off
Transmitter settings are reversed
ESC uses default soft Low Voltage
Cut off (LVC)
Weather conditions might be too cold
Battery is old, worn out or damaged
Battery Crating might be too small
Transmitter is too near boat during
linking process
Boat or transmitter is too close to large
metal object
Bind plug is left installed
Boat battery/transmitter battery
charge is too low
Transmitter may have been bound
to a different
(using different DSM
Protocol)
ESC switch is off
Repair rudder or adjust rudder and rudder
trim for straight running when control is at
neutral
Angle the fins a small amount right or left so
that the boat goes straight when the rudder
is at neutral
Replace or repair damaged parts and adjust
controls
Do a check of wires and connections,
connect or replace as needed
Rebind or select correct boat in transmitter
Replace ESC
Power on ESC switch
Do the Control Direction Test and adjust
controls on transmitter appropriately
Clean or replace water tubes
Recharge boat battery or replace battery
that is no longer performing
Postpone until weather is warmer
Replace battery
Use recommended battery
Move powered transmitter a few feet from
boat, disconnect and reconnect battery to
boat
Move boat or transmitter away from large
metal object
Rebind transmitter to boat and remove bind
plug before cycling power
Replace/recharge batteries
Bind boat to transmitter
Power on ESC switch
10 / 12
10 / 12
10 / 12

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Vector sr48 brushed

Inhaltsverzeichnis