Proper Use; For Safe Operation - led2work TUBELED 40 Element Betriebsanleitung

TUBELED_40 Element

1 | Proper use

The luminaire is used for illumination. The luminaire is intended for mounting in a lumi-
naire holder or mounting bracket.
The safety information and all other information in this manual must
be followed. Read the entire operating manual carefully before
mounting and turning on.
Keep the operating manual with the device. It must be stored and
handed over to third parties when the product is passed on.

2 | For safe operation

The operating parameters of the LED luminaire specified on the type plate must cor-
respond to the supply parameters of the machine or of the transformer.
Operate the luminaire only in a mounted status.
Under no circumstances may the luminaire be covered with cloths,
foils or similar. Object distance from the luminaire should be at
least 10 cm.
TUBELED_40 Element DC
Machines can emit voltage spikes due to various factors. These
voltage spikes in the power supply via machines should be avoided:
Only use regulated 24V DC switched-mode power supplies, not
transformers with rectifiers, as these can give rise to voltage spikes
due to inductance. Hot plugging should be avoided (connection of
the luminaire to a power supply which is already connected to the
mains), since this can lead to the destruction of the LED luminaire.
TUBELED_40 Element AC
Machines or systems can emit voltage spikes due to various
factors. These voltage spikes in the power supply via machines,
systems or units should be avoided:
During the operation of the luminaire in a 220 -240V power supply
net, it could be the cause, that machines (induction perpetrators)
inside the same power supply net cause interference spikes at
start. This deviations may only 10% max.
| 11
www.led2work.com