Declaration Of Conformity - Bosch GWS 11-125 CIH PROFESSIONAL Bedienungsanleitung

OBJ_BUCH-165-003.book Page 23 Friday, January 12, 2007 9:16 AM
The vibration emission level given in
WARNING
this information sheet has been meas-
ured in accordance
ised test given in EN 60745 and may be used to
compare one tool with another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.

Declaration of Conformity

We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents: EN 60745 according
to the provisions of the directives 89/336/EEC,
98/37/EC.
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
18.12.2006, Robert Bosch GmbH, Power Tools Division
D-70145 Leinfelden-Echterdingen
Assembly
Mounting the Protective Devices
Before any work on the machine itself, pull
the mains plug.
Protection Guard for Sanding
Place the protection guard 12
onto the spindle collar as
shown in the illustration. The
triangle marks on the protec-
tion guard must correspond
with the respective marks on
the gear case.
Press the protection guard 12
onto the spindle collar until the
shoulder of the protection
guard is seated against the
flange of the machine, and turn
the protection guard until it can
clearly be heard to engage.
1 609 929 L08 • 12.1.07
Adjust the position of the protection guard 12 to the
requirements of the work process. For this, press the
with a standard- release lever 1 upward and turn the protection guard
12 to the required position.
Note: The encoding keys on the protection guard 12
ensure that only a protection guard that fits the
machine type can be mounted.
Protection Guard for Cutting
The protection guard for cutting 13 is mounted in the
same manner as the protection guard for sanding 12.
Extraction Hood for Sanding
The extraction hood 7 can be used for low-dust sand-
ing of paint, varnish and plastics in conjunction with
the carbide grinding head 9 or the rubber sanding
plate 16 with a sanding sheet 17. The extraction hood
7 is not suitable for working metals.
A suitable Bosch vacuum cleaner can be connected
to the extraction hood 7.
The extraction hood 7 is mounted in the same manner
as the protection guard 12. The brush collar is
exchangeable.
Auxiliary Handle
Screw the auxiliary handle 5 on the right or left of the
machine head depending on the working method.
Vibration-dampening Auxiliary Handle
The vibration-dampening auxiliary handle reduces the
vibrations, making operation more comfortable and
secure.
Do not continue to use an auxiliary handle if it
is damaged.
Adjust the protection guard 12 in such a
manner that sparking is prevented in the
direction of the operator.
The protection guard 12 may be turned only
upon actuation of the release lever 1! Other-
wise the power tool may not continue to be
used under any circumstances and must be
taken to an after-sales service agent.
For cutting metal, always work with the pro-
tection guard for cutting 13.
For cutting stone, always work with the cut-
ting guide with dust extraction protection
guard 20.
Operate your machine only with the auxiliary
handle 5.
Do not make any alterations to the auxiliary
handle.
English | 23