Technical Data - Bosch GWS 11-125 CIH PROFESSIONAL Bedienungsanleitung

OBJ_BUCH-165-003.book Page 22 Friday, January 12, 2007 9:16 AM
Intended Use
The machine is intended for cutting, roughing, and
brushing metal and stone materials without using
water.
For cutting metal, a special protection guard for cut-
ting (accessory) must be used.
For cutting stone, a special extraction hood for cutting
with cutting guide (accessory) must be used.
With approved sanding tools, the machine can be
used for sanding with sanding discs.
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Release lever for protection guard
2 Spindle lock button
3 Thumbwheel for speed preselection
(GWS 15-125 CIEH/GWS 15-125 CITH)
4 On/Off switch

Technical Data

Angle Grinder
Article number
Rated power input
Output power
No-load speed
Grinding disc diameter, max.
Thread of grinder spindle
Kickback stop
Restarting protection
Reduced starting current
Constant electronic control
Speed preselection
Weight according to
EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries, these
values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.
Noise/Vibration Information
Measured values determined
EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 91 dB(A); sound power level
102 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
22 | English
5 Auxiliary handle
6 Grinder spindle
7 Extraction hood for sanding*
8 Mounting flange with O-ring
9 Carbide grinding head*
10 Clamping nut
11 Quick-clamping nut
12 Protection guard for sanding
13 Protection guard for cutting*
14 Grinding/cutting disc*
15 Hand guard*
16 Rubber sanding plate*
17 Sanding sheet*
18 Round nut*
19 Cup brush*
20 Cutting guide with dust extraction protection
guard *
21 Diamond cutting disc*
*The accessories illustrated or described are not
included as standard delivery.
GWS ... 11-125
PROFESSIONAL CIH
3 601 ... H30 1..
H30 B..
W 1100
W 660
rpm 11000
mm 125
M 14
–
kg 2.1
/II
Overall vibrational value (vector sum of three direc-
tions) determined according to EN 60745:
Grinding surfaces (roughing): Vibrational emission
according to
value a =9.0 m/s
h
Sanding with sanding discs: Vibrational emission
value a =5.0 m/s
h
*
15-125 15-125 15-125
CIH CIEH CITH
H30 2.. H30 3.. H30 4..
H30 C.. H30 D.. H30 E..
1500 1500 1500
860 860 860
11000 2800 2800
– 11000 – 9300
125 125 125
M 14 M 14 M 14
–
2.3 2.3 2.3
/II /II /II
2
, uncertainty K=2.0 m/s
2
, uncertainty K=1.5 m/s
1 609 929 L08 • 12.1.07
15-150
CIH
H30 5..
H30 F..
1500
860
9300
150
M 14
–
2.4
/II
2
.
2
.