Scheppach GK240ofx Originalbetriebsanleitung Seite 47

– Follow the maintenance instructions.
– Check the connection cable of the electric tool regularly and have it replaced by a
recognised specialist when damaged.
– Check extension cables regularly and replace them when damaged.
10 Pull the plug out of the outlet
– During non-use of the electric tool or prior to maintenance and when replacing tools.
11 Avoid inadvertent starting
– Make sure that the switch is switched off when plugging the plug into an outlet.
12 Use extension cables for outdoors
– Only use approved and appropriately identified extension cables for use outdoors.
– Only use cable reels in the unrolled state.
13 Remain attentive
– Pay attention to what you are doing. Remain sensible when working. Do not use the
electric tool when you are distracted.
14 Check the electric tool for potential damage
– Protective devices and other parts must be carefully inspected to ensure that they
are fault-free and function as intended prior to continued use of the electric tool.
– Check whether the moving parts function faultlessly and do not jam or whether parts
are damaged. All parts must be correctly mounted and all conditions must be fulfilled
to ensure fault-free operation of the electric tool.
– Damaged protective devices and parts must be properly repaired or replaced by
a recognised workshop, insofar as nothing different is specified in the operating
manual.
– Damaged switches must be replaced at a customer service workshop.
– Do not use any faulty or damaged connection cables.
– Do not use any electric tool on which the switch cannot be switched on and off.
15 Have your electric tool repaired by a qualified electrician
– This electric tool conforms to the applicable safety regulations. Repairs may only
be performed by an electrician using original spare parts. Otherwise accidents can
occur.
16 Important!
– For your own safety you must only use the accessories and additional units listed in
the operating instructions or recommended or specified by the manufacturer. The
use of mounted tools or accessories other than those recommended in the operating
instructions or catalog may place your personal safety at risk.
17 Noise
– Wear ear muffs when you use the compressor.
18 Replacing the power cable
– To prevent hazards, leave the replacement of damaged power cables strictly to the
manufacturer or a qualified electrician. There is a risk of electric shock!
www.scheppach.com
GB | 47