Preparing The Load Items - Miele APFD 210 Gebrauchsanweisung

Preparing the load items

Remove any coarse soiling from the
load items.
Check that the load items are suitable
for cleaning in a dishwasher.
Notes

Risk of damage caused by acids
and solvents.
Acid or solvent residues, especially
hydrochloric acid or chlorides, must
not get inside the wash cabinet.
Do not use acids or solvents in the
wash cabinet.

Damage caused by load items
soiled with ash, sand, wax, lubricat-
ing grease or paint.
These items will damage ProfiLine
and fresh water dishwashers.
Do not wash items soiled with ash,
sand, wax, lubricating grease or
paint in ProfiLine or fresh water dish-
washers.
Position the bottles in the designated
locations in the bottle basket.
Please note:
 Load the bottles so that water can
access all surfaces.
The bottle basket has 16 bottle holders.
 Load the bottles onto the injector
nozzles with the openings pointing
down.
en - Application technology
The bottle basket and holders can
only accommodate bottles with a
maximum diameter of 95 mm.
The maximum number of bottles that
can be loaded for cleaning is 16.
Insufficient cleaning
The height of the bottles loaded on
the nozzles at the front  must not
exceed 200 mm.
Liquid dispensing is recommended if
all of the bottles loaded for cleaning
are taller than 200 mm.
 Start the wash programme.
Recommended wash programme:
glassware
For more information, see the operating
instructions for the dishwasher you are
using.
1
23