Removing The Battery Pack - Kobold VB100 Gebrauchsanleitung

Removing the battery pack

To remove the battery pack, proceed as follows:
1. Switch the Kobold VB100 Cordless Vacuum Cleaner
off at the main switch.
2. Disconnect the cordless vacuum cleaner from the
AC charger.
3. Open the filter cover as described in chapter
"Opening the filter cover" on page 30.
4. Reach inside the cordless vacuum cleaner, take hold
of the battery pack by the green strap
downwards to remove it.
Charging the removed battery pack
You can also charge the battery pack separately. This is
recommended when using an additional battery pack,
for example.
To charge your battery pack, proceed as follows:
1. Connect the AC charger
2. Note the prescribed voltage of 220-240 V.
3. Connect the AC charger to the charging point on the
battery pack .
4. Ensure that the plug is fully inserted.
The battery pack gets slightly warm while charg-
ing.
34
and pull
to the power supply.