Ronda R150 Bedienungsanleitung

User's Manual English
Movement Caliber
RONDA mecano
– R150
You have decided to buy a watch, which was assembled by a
watchmaker using a Ronda movement. Please note that no watches
are produced or distributed under the Ronda brand.
In case of repairs, guarantee claims and questions concerning the
functioning of a watch, purchasers and consumers should contact
their retailer or the watch manufacturer, for which the relevant infor-
mation can be found in the sales or guarantee documentation provi-
ded with the watch.
An automatic movement uses the natural movements of the wearer's
arm to wind the mainspring of the movement via the built-in oscillating
weight. In order for a watch with a RONDA R150 automatic movement
to run self-sustainingly, RONDA recommends a daily wearing time of 12
hours. If the watch is worn for a shorter period of time, it is advisable to
wind up the movement by turning the stem a few times, especially if the
wearer is only slightly active.
If the movement has come to a standstill, it is recommended restarting
the movement by turning the adjusting stem 16 times with the crown in
position I.
The automatic movement RONDA R150 has a power reserve of at least 40
hours when fully wound. If the watch is not worn or moved for more than
40 hours, it will stop after this time and must be wound up again.
BA_R150_en_de_fr.indd 1-2 BA_R150_en_de_fr.indd 1-2
Cal. R150
Crown A
Pos. I Position of rest (watch running)
Winding while stopped
The maximum power reserve can be restored by turning
the crown clockwise around 30 times.
Pos. II Quick-change correction for date
– Pull the crown out to position II (watch still running).
– Turn the crown anticlockwise until the required date
appears.
– Push the crown back into position I.
Pos. III Setting the time
– Pull the crown out to position III (watch stopped).
– Turn the crown, until the current time is displayed
(remember the 24-hour cycle).
– Push the crown back into position I.
I II III
8/2021
02.07.21 12:30 02.07.21 12:30