Shark Explore-R Bedienungsanleitung Seite 15

E
Perform the operation in reverse. Insert
the front plastic part in its housing. The 3 clips
must be properly engaged (E).
Clip the 2 snaps on the rear of the cap (F).
H
Insert the rear part of the neck support (H).
Slide the side edges under the seal (I).
CAP AND ChEEkS
F
Replace the cheeks pads by clipping it (G).
IMPORTANT: Check that the chin straps aren't
twisted or wedged under the cheeks pad.
NECk SuPPORT
I
Finish
for the front (J).
TExTIlE PARTS - REPlACE
J
by doing the
G
same operation
17