Basic Lifting Guide; Unboxing The Package; Installation Location - LG RESU 16h Rrime Bedienungsanleitung

3.1.2

Basic lifting guide

Refer to below guide for lifting and carrying the Battery Control Unit and Battery Modules
during installation.
Handling position
Handling position
Handling position
Handling position
Handling position
Handling position
Battery Control Unit
Battery Control Unit Battery Module (1
Battery Module
Battery Control Unit
Battery Control Unit
Battery Module
Battery Control Unit
3.1.3

Unboxing the Package

(1 installer)
Battery Control Unit
6
Installer A
Battery Module Battery Module
(1 installer) (2 installer)
Battery Module Battery Module
Battery Module (2
Battery Module
(1 installer) (2 installer)
(1 installer) (2 installer)
installer) installers)
Battery Module
(2 installer)
Battery Module Battery Module
(1 installer) (2 installer)
1. Cut the packing strap and remove
the top lid.
2. Remove the sleeve.
3. Pull out the Battery Control Unit. and
the Spacers (x2).
Installer B
CAUTION
According to regional regulations, several people may be required for moving equipment.
3.1.4

Installation Location

Requirements:
• There must be no highly flammable or explosive materials nearby.
• The ambient temperature should be within the range of -4°F to 122°F (-20°C to
50°C).
• The battery pack must be installed on flat leveled ground that can support its
weight.
• Product shall be installed indoors (ex. in a basement or a garage) or outdoors
under an eave and out of direct sunlight.
Recommendations:
• The building should be designed to withstand earthquakes.
• The area should be waterproof and properly ventilated. (IP55)
• The product should be installed out of reach of children and animals.
CAUTION
If the ambient temperature is outside operating range, the battery pack will stop
operating to protect itself. The optimal temperature range for the battery pack to operate
is from 59℉ to 86℉(15℃ to 30℃).
Frequent exposure to harsh temperatures may deteriorate the performance and life of the
battery pack.
4. Pull out the bundled items, including
the Module Connecting Plate.
5. Pull out Battery Module B.
B
B
6. Pull out Battery Module A.
A A