Suspension Mount Bracket - HEATSTRIP ELEGANCE Bedienungsanleitung

Chain / Wire Suspension Mount
®
HEATSTRIP Elegance can by suspended using chain or wire to lower the installation height from high outdoor or indoor
roofs of ceilings.
Thermofilm does not provide any dedicated installation kit for this type of mounting, however the following information may
be used to assist in safely installing the HEATSTRIP
Any chain or wire must be suitably rated to withstand the weight of the heater.
The use of chain or wire mounting is NOT recommended for unprotected outdoor installations.
It is recommended to use a the component from the standard bracket kit (shown below) which is supplied with each heater
to attach any chain or wire to the heater.
For minimum distance requirements between poles please refer to page 14.
Diagram above shows one potential means
of installation using chain or wire
16
®
Elegance.