Klarstein FROSTIK Bedienungsanleitung Seite 39

Operation
1. After connecting to the power supply, press the ON/OFF button on the remote
control to switch on the appliance.
2. Press MODE to select the desired operating mode: AUTO, COOL, DRY, FAN.
3. Press "+" or "-" to set the desired temperature. The temperature cannot be set
in AUTO mode.
4. Press FAN to set the desired fan speed: AUTO, LOW, MEDIUM and HIGH.
Replacing the batteries
1. Press the retaining clip of the
battery compartment of the
remote control and slide the cover
off in the direction of the arrow.
2. Replace the old batteries with two
LR03 batteries. Make sure that the
polarity is correct.
3. Put the battery cover back on.
Note: The distance between the signal transmitter and the signal receiver
must not exceed 8 metres. If the signal in the room is disturbed by fluorescent
lights, neon lights or mobile phones, move the remote control closer to the unit.
Replace the batteries with the same type. Remove the batteries if you do not
use the remote control for a long time.
EN
39