IKEA Kylig Handbuch Seite 17

ENGLISH
Problem
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the Fast Freezing,
or after changing the tem-
perature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set.
Possible cause
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The Fast Freezing function
is switched on.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
The Fast Freezing function
is switched on.
Solution
Contact the nearest After
Sales Service.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "Fast Freezing func-
tion".
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off Fast Freezing man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "Fast
Freezing function".
17