Herunterladen Inhalt Inhalt Diese Seite drucken

Scanic 575 Pro2 Bedienungsanleitung Seite 4

Astute
Inhaltsverzeichnis

Werbung

Benutzen Sie nur vorschriftsmäßige Verlängerungskabel!
Lassen Sie das Netzkabel nicht mit anderen Kabeln in
Kontakt kommen!
Stellen Sie bei Installation, Betrieb, Transport und Lage-
rung stets sicher, dass keine Kabel frei herumliegen!
Fassen Sie Netzkabel, Netzstecker und Netzsteckdosen
nie mit nassen oder feuchten Händen an!
Trennen Sie das Produkt bei Nichtbenutzung und vor je-
der Reinigung vom Netz! Fassen Sie dazu den Netzste-
cker an der Grifffläche an und ziehen Sie niemals an der
Netzleitung!
Das Produkt darf keinesfalls mit Dimmerpacks betrieben
werden.
3. Gehäuse
ACHTUNG:
LEBENSGEFAHR! VERBRENNUNGSGEFAHR! BRANDGE-
FAHR! KURZSCHLUSSGEFAHR!
Stellen Sie bei Installation, Betrieb, Transport und Lage-
rung des Produktes stets sicher, dass keine Erschütterun-
gen oder sonstige Gewalteinwirkungen auf das Gehäuse
einwirken können!
Das Gehäuse darf während des Betriebs keine anderen
Geräte oder Gegenstände berühren!
Leicht entflammbare Materialien wie z.B. Dekorations-
materialien und andere Gegenstände und Flächen müs-
sen mindestens 3 m vom Gehäuse entfernt sein! Halten
Sie einen Sicherheitsabstand von mindestens 50 cm zu
Wänden.
Das Gerät darf stehend nur auf feuerfestem Untergrund
(kein Teppich!) betrieben werden.
Es muss immer eine einwandfreie Luftzirkulation statt-
finden.
Berühren Sie während des Betriebs das Gehäuse nicht –
es erhitzt sich. Erst ca. 5 Minuten nach Ende des Betriebs
können Sie das Gehäuse wieder berühren!
Tragen Sie das Gerät nur an den Tragegriffen. Tragen Sie
das Gerät niemals an den Projektorarmen!
Es darf keinerlei Flüssigkeit in das Gehäuse eindringen,
da dies die Schutzisolierung reduzieren oder Kurzschlüs-
se auslösen könnte, was zu tödlichen Stromschlägen füh-
ren kann! Im Fall von eingedrungener Flüssigkeit müssen
Sie sofort den Netzstecker ziehen, das Produkt gegen
unbeabsichtigten Betrieb sichern und sich mit Ihrem
Fachhändler in Verbindung setzen! Schäden, die durch
Flüssigkeiten im Gehäuse entstehen, sind von der Ge-
währleistung ausgeschlossen.
Es dürfen keine Metallteile oder sonstige Gegenstände
in das Gehäuse gelangen, da dies die Schutzisolierung
reduzieren oder Kurzschlüsse auslösen könnte, was zu
tödlichen Stromschlägen führen kann! Im Fall von ein-
gedrungenen Metallteilen oder sonstigen Gegenständen
4
Use extensions cords in compliance with specifications only!
Do not allow the mains cord to come into contact with
other cords!
Ensure during installation, operation, transport and sto-
rage that none of the cables are freely exposed!
Never touch the mains cord, mains plug and outlets
with wet or damp hands!
When not using the product, and prior to cleaning al-
ways disconnect the product from mains! To do so, hold
the mains plug by the handling surface and never pull
the mains cord!
Never connect the device to dimmer packs!
3. Housing
ATTENTION:
DANGER OF LIFE! RISK OF BURNS! RISK OF FIRE! RISK
OF SHORT CIRCUIT!
Always ensure during installation, operation, transport
and when storing the product that no shocks or other
forces impact the housing!
The housing must not touch onto any other devices or
objects during operation!
Easily flammable materials e.g. dekoration material and
other surfaces and objects must maintain a minimum
distance of 3 m to the housing! Walls must maintain a
minimum distance of 50 cm to the housing!
The device must be installed on a fireproof surface only
(no carpet)!
Always ensure a proper circulation of air.
Do not touch the housing during operation – it will heat
up. The housing is safe to touch approx. 5 minutes fol-
lowing the end of operation!
The device must never be carried via the projector
arms. Use the carrying handles only!
Fluids must not enter the housing as this could reduce
the protective insulation and may trigger short circuits
which may lead to fatal electric shocks! If fluids have
entered, disconnect the mains plug immediately and
secure the product against unintentional operation and
contact your specialised dealer! Damage caused as
a result of fluids entering the housing is exempt from
warranty.
No metal parts or other items must enter the housing
as this may reduce the protective insulation or trigger
short circuits which may lead to fatal electric shocks!
If metal parts or other items have entered, disconnect
the mains plug immediately, secure the product against
unintentional operation and contact your specialised

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis