Explanation Of Functions; Slide Switch; Programming The Run Times; Deleting The Run Times - Becker Centronic MemoControl MC441-II Montage- Und Betriebsanleitung

Slide switch

Each Centronic radio receiver for roller shutter and blind installations can save
switching times for one UP and one DOWN movement. In the " " operating
mode, this movement is repeated every 24 hours. It does not matter what pos-
ition the slide switch is in when programming the switching time. Any stored
switching times are overwritten.

Programming the run times

1. If necessary, run the roller shutter or blind to the opposite limit position.
2. Wait for the time you wish the automatic drive command to be executed.
3. At the desired time, press and hold the relevant direction button until the
drive briefly stops after approx. 6 seconds and then continues to the limit
position.
4. Release the direction button.
The receiver has saved the current time for this direction of travel. Proceed in
exactly the same way with the other direction of movement.
In the slide switch position " ", no automatic drive commands will be ex-
ecuted. The saved run times are retained.

Deleting the run times

When deleting, both run times are always deleted.
To delete the UP and DOWN run time, press the STOP button for 10 seconds.
Acknowledgement is given by a "click click" from the drive, or by a "shift" of
the shading solution.
The run times are now deleted.
Channel
The channel of a hand-held transmitter can be programmed into one or more
receivers. One receiver is operated through an individual command, several
receivers through a group command.

Explanation of functions

17 - en