AEG BSE778280M Benutzerinformation Seite 107

Preheat the empty oven before the first use.
Step 3
Set the maximum temperature for the function:
Let the oven operate for 15 min.
The oven can emit an odour and smoke during preheating. Make sure that the room is ventila‐
ted.
5.6 How to set: Water hardness
When you connect the oven to the mains you have to set the water hardness level.
Use the test paper or contact your water supplier to check the water hardness level.
Step 1
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later than 1
min after test.
You can change the water hardness level in the menu: Settings / Setup / Water hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium deposit
and the water classification. Adjust the water hardness level according to the table.
Water hardness
Level dH
1 0 - 7
2 8 - 14
Step 2
Shake the test paper
to remove the excess
of water.
Test paper
BEFORE FIRST USE
.
Step 3
After 1 min, check
water hardness with
the table below.
Calcium de‐ Calcium de‐
posit (mmol/l) posit (mg/l)
0 - 1.3
1.4 - 2.5
Step 4
Set the water hardness
level: Menu / Settings /
Setup / Water hard‐
ness.
Water classi‐
fication
0 - 50 soft
51 - 100 moderately
hard
107/376