Adjusting The Insertion Depth - Prebena PKT-8-PR100 Originalbetriebsanleitung

In particular, you must not use the contact release
with automatic reset release setting for the following
purposes:
- For applications such as closing boxes or crates
▶ In these cases, set the selector switch on the control panel to
single release.
Single triggering
With single triggering, pressing the triggering safety device against
the material and then pressing the trigger button causes one single
nail to be driven into the material.
Contact triggering with automatic reset
With contact triggering the trigger button is pressed and held. Then
pressing the triggering safety device causes one nail to be driven
into the material. If the triggering safety device is then pressed
against the material an additional time within 5 seconds, another nail
is driven in, etc.
After 5 seconds without activation or contact of the triggering safety
device with the material, the tool reverts to the "single triggering"
triggering process.

Adjusting the insertion depth

You can adjust the insertion depth for the nails. The fastener driving
tool has a setting wheel on the triggering safety device to do this.
The pictogram on the side (item 2 in the
diagram below) can be found on the housing
of the fastener driving tool:
This pictogram shows the direction the
setting wheel must point in to reduce or
increase the insertion depth.
and installing transport safety systems on trailers or
trucks.
Operation
47