Operation; Maintenance - Makita M4000 Betriebsanleitung

ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the nozzle (Fig. 3)
Align the pin protruding inside the nozzle with the notch
on the tool, push the nozzle to the blower outlet and then
securely turn the nozzle clockwise.
To remove the nozzle, turn counterclockwise and pull it
out.
Installing the sash nozzle (Fig. 4)
Sash nozzle is convenient for operation in a sash rail,
corner or tight place between cabinets. Secure the sash
nozzle by inserting it into the nozzle from the back of the
nozzle.
Install the nozzle with the attached sash nozzle. (Fig. 5)
Sash nozzle storage (Fig. 6)
When not in use, the sash nozzle can be conveniently
stored at the bottom of the tool as shown in the figure.

OPERATION

Blowing (Fig. 7)
Point the tool to the object to be blown off and turn on the
tool.

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K): 3 dB (A)
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: operation without load
Vibration emission (a
Uncertainty (K): 1.5 m/s
• The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
4
ENG905-1
): 90 dB (A)
pA
): 101 dB (A)
WA
ENG900-1
2
): 2.5 m/s or less
h
2
ENG901-1
WARNING:
• The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of exposure in
the actual conditions of use (taking account of all parts
of the operating cycle such as the times when the tool
is switched off and when it is running idle in addition to
the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Blower
Model No./Type: M4000
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
1. 12. 2014
Yasushi Fukaya
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
ENH101-18
Director