Makita DFL201F Bedienungsanleitung Seite 7

LED indicator / Beeper
► Fig.6: 1. Lamp 2. LED indicator
LED indicator / Beeper on the tool shows the following functions.
Status of the LED indicator/beeper
LED indicator
Lights up in
Green
A series of very
Red
short beeps
Blue
White in order
Lights up in green
for approximately
one second.
Blinks in purple A series of long
slowly. beeps
Lights up in purple A long beep
Lights up in red and A series of short
green alternatively beeps
A series of short
Blinks in red quickly.
beeps
Blinks in red and
A long beep
yellow alternatively.
Function
Beeper
Check LED, light and beeper
(when pulling switch trigger
for the first time after
installing a battery
cartridge into the tool)
Auto-stop fastening
Warning for battery
cartridge capacity
Checking the remaining
battery capacity, Autostop
Anti-reset of controller
Failure of motor
Overheat
Warning against
insufficient fastening
Double-hitting detection
Status
Make sure that green, red,
blue, white LED lights up
and beeper beeps properly
This function works when
the tool has reached the
preset fastening torque
and normal tightening
has been completed.
This helps overtightening
to be avoided.
This indicates the
appropriate time to replace
the battery cartridge when
the battery power
becomes low.
This function works when
the battery power is
almost used up.
At this time, tool stops
immediately.
This function works when
an abnormal drop of the
battery voltage occurs for
some reason, and the tool
stops.
This function works
when motor fails.
This function works when
the temperature of the
controller or motor goes
up very highly, and the
tool stops.
Fastening is imcomplete
when switch trigger of tool
is released before clutch
activation.
This function works
when a screw is
refastened after fastening.
7 ENGLISH
Action to be taken
Replace the battery
with fully charged one.
Replace the battery
with fully charged one.
Replace the battery
with fully charged one.
Take it to a Makita
Authorized Service
centers.
Remove the battery
cartridge immediately
and cool the tool down.