Haier HW80-B14876N Bedienungsanleitung Seite 29

EN
10.7 Fresh Water Connection
Make sure that the gaskets are inserted.
1. Connect the water inlet hose with the angled
end to the appliance (Fig. 10-11). Tighten the
screw joint by hand.
2. The other end connect to a water tap with a
" 3/4" thread (Fig. 10-12).
10.8 Electrical Connection
Before each connection check if:
▶ power supply, socket and fusing are appropriate to
the rating plate.
▶ the power socket is earthed and no multi-plug or
extension are used.
▶ the power plug and socket are strictly according.
▶ Only UK: The UK plug meets BS1363A standard.
Put the plug into the socket (Fig. 10-13).
WARNING!
▶ Ensure always that all connections (power supply, drain and fresh water hose) are rm,
dry and leack free!
▶ Take care these parts are never to be crushed, kinked, or twisted
▶ If the supply cord is damaged, it must be replaced by the service agent (see warranty
card) in order to avoid a hazard. .
10-Installation
10-11
10-12
10-13
29