HP DesignJet 430 Aufbauanleitung Seite 3

Textlegs Page 2 Thursday, October 23, 1997 5:29 PM
Note: If the roll feed assembly is installed on the printer, it must be removed before the printer can be
installed on top of the stand assembly.
11 . Set the printer on the legs assembly so the entrance to the bin assembly is underneath the
front of the printer. Secure the printer to the stand assembly using two screws on each leg.
Important: Ensure the screws are fully tightened.
To disassemble the Media-Bin (See Reverse), perform the following steps:
1. With a flat screw driver, carefully lever apart the Capping Strip assembly through the holes
at the bottom.
2. Carefully lever the retaining clips from the Cross Brace Assembly.
3. Carefully lever the retaining clips from the Media-Bin Support.
4. Remove the Media-Bin Arms.