Automatic Shutdown - Grundig SI 4550 Bedienungsanleitung

OPERATION _________________________________
Lime removing feature (Self-
Clean)
It minimizes the lime particles accumulated in the
steam reservoir of your iron.
Use the self-clean feature once in every 2 to 3
weeks. If the water in your region is very hard (if
lime particles fall down from the soleplate of the
appliance), we recommend to use the self-clean
function more frequently.
1
Unplug your iron.
2
Fill the water tank up to the MAX mark.
3
Plug in the appliance to a grounded wall socket
and set the temperature setting dial to MAX.
4 Unplug the iron when the thermostat warning
light turns off.
B
5
Hold the iron over the sink and press self clean
button . During this process, the water in
D
the water tank comes down into the steam
generation reservoir quickly and is released
through the soleplate holes along with the lime
particles (if any).
6 When the entire amount of water is discharged
from the tank, release the self clean button
If the iron still contains impurities, repeat this
process.
7
After the lime removal process is completed;
plug in the iron and make sure that the iron
soleplate is heated. When the iron reaches to
the adjusted ironing temperature, unplug the
appliance and gently iron on an old cloth. Keep
ironing until the water and lime stains left on the
soleplate are removed. Wait until the iron cools
down before storing it.
Caution
•
Do not add vinegar etc. and other lime removing
substances into the water tank.
22 ENGLISH
Lime protection system
(Anti-Calc)
The lime protection system in the water tank of
your iron prevents clogging of the steam holes.
Lime protection system is always active and there
is no need to replace it.

Automatic shutdown

•
If the appliance is hold stationary for 30 seconds
while in horizontal position, it will be automati-
cally turned off.
•
If the appliance is hold stationary for 7-10 min-
utes while in upright position, it will be automati-
cally turned off.
• If the appliance is hold stationary for 30 seconds
while in a leaned (right or left) position, it will be
automatically turned off.
•
If the appliance is moved in horizontal position it
will be turned on..
1
To reheat the iron, lift it up and move it gently.
The thermostat warning light
2
When the temperature of the soleplate falls
under the set iron temperature, the thermostat
.
D
warning light
3 If the thermostat warning light
after moving the iron, wait until it turns off again
before starting to iron.
Note
• If the thermostat warning light
nated after moving the iron, the soleplate is still
at the required temperature and the iron is ready
to use.
•
In case of automatic turn off the auto-off light
flashes.
B
•
It may take 60 seconds for the soleplate
reach the previously set temperature.
turns off.
B
illuminates.
B
is illuminated
B
is not illumi-
B
to
E